1. Remove Star Grips from battery cove
2. Open battery cover and remove battery if installed
3. Disconnect six (6) connectors from the electronic box
4. Push The five (5) disconnected connectors into the frame channel on both sides
5. Locate the "lift straps" one the Electronics Box (EB)
6. Pull Up and out towards the outer edge of the device body at approx. 45 degrees.
7. Install the new Electronic Box in reverse order of removal.
8. Reconnect six (6) connectors. Each connector is unique and only fits its corresponding connection.
🔺Warning🔺
If cables are not properly tucked into the frame channel area (shown in red circles below) closing the lid can lead to damage, destruction, or severing of cables.
9. Re-Install and connect battery #2, then close and secure the battery.